Including

• Knuckle boom cranes
• Vehicle transporters
• Drill pipe trucks
• Water trucks

Low ground pressure 95hp agricultural type tractors fitted with dual wheels

These are used for/as

• Winch platforms
• Drill pipe transportation
• Water transportation
• Front end loader with bucket and fork attachments

• Multiple 4x4 utility type support vehicles
• Double cab crew carrier utes/light trucks
• Drill pipe and casing trailers
• Bulk fuel trailers
• Tandem axle trailers

Portable and plug in type water reticulation and mud pumps with volumes and pressures up to that of our oil field skid mounted Gardner Denver model T.H.E. Triplex mud pump (max volume 462gpm @300spm and max pressure 1,557psi @50spm, with 5-1/2” liners).

• High volume and high pressure compressors with in-house capacity of up to 400cfm @ 200psig
• We use rental and lease compressors to complement our own and have available to us compressors with capacities of up to 1050cfm and 500psig

Portable surface tanks and slush type pits.

• Velocity shear type funnels
• Paddle type hydraulic

Ability to test drilling fluid properties in-house such as; viscosity, mud weight, filtrate properties, sand content, Ph, KCI%, etc

Current in-house capacity and equipment to run, handle and make up Range III casing sizes up to 13-3/8” diameter. This includes cementing swedge’s and hydraulic make up tooling. 

• 1 x hydraulic spinner/toquer for casing sizes from 4-1/2" through to 13-3/8".
• Lifting plugs and holding plates for 4-1/2" LTC and VAM, 7" STC, LTC and BTC, 9-5/8" LTC and BTC, and 13-3/8" BTC casings.
• The ability with Rig #1 to handle, run, make-up and cement the full range of Range III (up to 14.63m) casings from  4-1/2" through to 13-3/8" sizes in-house. Rig(s) #3 and #48 handle, run, make-up and cement the full range of Range II.

• 1 x 5 station well control system (Koomy) complete with remote drillers control panel. Mounted on a four axle pull trailer and powered by 1 x 88kva main generator, 1 x 7.5kva standby generator, 1 x 175cfm compressor.
• 1 x 11"3000 psi annular preventer
• 1 x 11" 3000 psi double ram BOP with 1 x blinds and either 1 x 2-7/8" or 3-1/2" or 4-1/2" pipe ram.
• 1 x 11" 3000 psi top and bottom flanged drilling spool.
• 1 x 11" 3000 psi top to 9" 3000 psi bottom flanged drilling spool.
• 1 x 11" 3000 psi top to 7-1/16" 3000 psi bottom flanged drilling spool.
• 1 x 4-1/16" 3000 psi manual gate valve (choke).
• 1 x 4-1/16" 3000 psi hydraulic gate valve (choke).
• 1 x 2-1/16" 3000 psi manual gate valve (kill).
• 1 x 2-1/16" 3000 psi non return valve (kill).
• 1 x Guiberson (Cameron) wire-line stripping head complete with remote control, auto trip release and kill/flood provision.
• "I" BOP with 2-7/8" API IF connections.
• Kelly Cock with 2-7/8" API IF connections.

• Multiple Personnel Gas Detectors
  Drager X-am 2000 gas detectors, capable of screening four separate gas parameters consecutively. These units are fitted with visual, audible and vibration warning systems. 
• Vacuum Pump
  Drager pump X-am 1/2/5000. Provides the ability to remotely detect for gases from a cellar rat hole, mud gas trap or similar.

Multiple Drager brand "re-generative" and "bottle and hood type" personnel escape units.

Gardner Denver T.H.E. triplex hish pressure / high volume mud pump powered by a Cummins diesel engine (additional rental units available).

• Sullair 400cfm 200psi trailer mount
• Sullair 175cfm 125psi trailer mount
• Atlas Copco 950cfm 350psi (rental)

Multiple Caterpillar powered 4000w telescopic mast trailer mounted units (additional rental units available).

• Laboratory cabinet. Used to measure drilling fluid properties so as the drill hole integrity and safety is controlled and maintained without excessive additive usage (potassium iron concentration, gel strength filter cake properties, viscosity, pH, density, and more).
• Additional marsh funnels (for drilling fluid viscosity measurement) and mud balance (for monitoring drilling fluid density) units.